How deep are wells in Erwin Lake, CA?

The average well depth in Erwin Lake, California is 200 feet, based on 28 wells on record. Well depths range from 105 to 330 feet depending on geology and location.

How much does it cost to drill a well in Erwin Lake, CA?

Well drilling costs in Erwin Lake typically range from $9,000-$15,000 based on the 200-foot average depth. Call Southern California Well Service at (760) 440-8520 for a free estimate.

Average Well Depth in Erwin Lake, CA

Well Statistics for Erwin Lake

200ft

Average Depth

Wells on Record

105-330ft

Depth Range

31.1

Avg Yield (GPM)

Need a Well Drilled in Erwin Lake?

Expert well drilling, pump installation, and repair service in San Bernardino County.

📞 (760) 440-8520 Get Free Estimate →

Well Depth Distribution in Erwin Lake

Based on 28 wells drilled in Erwin Lake, California, the average depth is 200 feet. The median depth is 200 feet, which represents the typical well depth in the area.

105ft
Shallowest 200ft
Average 330ft
Deepest

Shallowest well: 105 feet
Deepest well: 330 feet
Average depth: 200 feet
Median depth: 200 feet

Geology and Groundwater in Erwin Lake

Erwin Lake benefits from relatively shallow groundwater, with wells averaging just 200 feet deep. The area's alluvial deposits and sedimentary formations allow easier access to productive aquifers. Shallower wells in this region typically use rotary drilling methods and can often be completed more quickly and at lower cost than deeper bedrock wells.

The average static water level (depth to water when the pump is off) in Erwin Lake wells is approximately 47 feet below ground surface.

Drilling Trends & Well Use

Wells Drilled by Decade

1990s

2000s

2010s

2020s

Wells by Use Type

Domestic 27 (96%)

Other 1 (4%)

Estimated Drilling Cost in Erwin Lake

Based on the average well depth of 200 feet, drilling a new well in Erwin Lake typically costs between $9,000 and $15,000. This includes drilling, casing, pump installation, and basic connections. Actual costs vary based on geology, access, and permit requirements.

🔍 Try our free Well Depth Lookup Tool to check well records near your specific address.

📍 Nearby Cities — Well Depth Data

📚 Related Resources

Get Expert Advice for Your Erwin Lake Property

Southern California Well Service has drilled hundreds of wells across San Bernardino County. We know the local geology and can give you an accurate depth and cost estimate.

Call (760) 440-8520

Licensed C-57 Contractor. CSLB License #1086994.| San Diego, Riverside & San Bernardino Counties

We service all major pump brands including Franklin Electric, Grundfos, Goulds (Xylem), and Sta-Rite (Pentair). Our trucks carry common parts and components for same-day repairs.

Frequently Asked Questions

How do I know if my well pump needs repair?

Common signs include: no water or low pressure, pump cycling on and off rapidly (short cycling), unusual noises, dirty or sandy water, and higher-than-normal electric bills. Any of these warrant a professional inspection.

How much does well pump repair cost?

Simple repairs like pressure switch replacement run

50-$300. Motor or pump replacement typically costs ,500-$4,500 depending on well depth and pump type. We diagnose the issue before recommending repairs.

Can I repair my well pump myself?

Surface-level issues like pressure switch adjustment or breaker resets are safe DIY tasks. However, anything involving pulling the pump from the well requires specialized equipment and should be handled by a licensed contractor to avoid damaging the well casing.

Continue learning about well maintenance and troubleshooting