Pressure Tanks for Hemet Wells
Your pressure tank is critical for protecting your well pump and maintaining steady water pressure. In Hemet, where wells produce 10-30 GPM (valley), 3-10 GPM (hills) from San Jacinto Valley alluvium (valley) and granite (hills), proper tank sizing and maintenance is essential.
How Pressure Tanks Work
A pressure tank stores pressurized water so your pump doesn't have to run every time you turn on a faucet. Key benefits:
- Reduces pump cycling (extends pump life)
- Maintains steady pressure throughout the house
- Provides small reserve for power outages
- Critical for Hemet wells with yields of 10-30 GPM (valley), 3-10 GPM (hills)
Sizing Pressure Tanks for Hemet Wells
Tank size depends on your well's flow rate and household demand:
- Small households (1-3 people): 20-30 gallon tank for Hemet wells producing 10
- Medium households (4-5 people): 40-60 gallon tank
- Large households or farms: 80-120 gallon tank, especially if well yield is on lower end (10-30 GPM (valley), 3-10 GPM (hills))
Pressure Tank Considerations for Hemet
Hemet wells in San Jacinto Valley alluvium (valley) and granite (hills) typically produce 10-30 GPM (valley), 3-10 GPM (hills). This affects tank sizing:
- Lower yields need larger tanks to reduce pump cycling
- Higher yields can use smaller tanks but still need adequate capacity
- Water quality (very hard water (15-25 grains), high TDS) affects tank lifespan
Signs Your Hemet Pressure Tank is Failing
- Waterlogging: Pump cycles on/off rapidly (short cycling)
- Low pressure: Water pressure drops suddenly, especially upstairs or at far fixtures
- Tank leaking: Water pooling around base, rust spots
- No air cushion: Tank sounds "full" when tapped (should sound hollow at top)
- Pump running constantly: Tank can't hold pressure
Common Pressure Tank Problems in Hemet
Based on local conditions and San Jacinto Valley alluvium (valley) and granite (hills):
- Extreme hard water scale, aging well infrastructure, declining water tables, TDS over 1000 in some areas
- Hard water (15-25 grains) causes sediment buildup inside tank
- Water quality issues (very hard water (15-25 grains), high TDS) can corrode bladder or tank interior
Pressure Tank Maintenance
- Annual inspection: Check pre-charge pressure (should be 2 PSI below cut-in)
- Drain sediment: Especially important with Hemet water (very hard water (15-25 grains), high TDS)
- Check bladder: Bladder tanks last 5-10 years depending on water quality
- Monitor pressure switch: Should cut in around 40 PSI, cut out around 60 PSI
Tank Replacement for Hemet Wells
When it's time to replace your pressure tank, we:
- Size correctly: Based on your well's 10-30 GPM (valley), 3-10 GPM (hills) yield and household needs
- Choose quality: Bladder tanks from top manufacturers (Well-X-Trol, Amtrol)
- Professional install: Proper placement, piping, pressure settings
- Test thoroughly: Verify pressure, flow rate, pump cycling
Service area: Florida Ave corridor, East Hemet, Diamond Valley, Winchester, Sage, and throughout Hemet.
Response time: 50 min from Ramona, 30 min from Anza.
Pressure tank service in Hemet
Call (760) 440-8520 for tank sizing, replacement, or repair.