Pressure Tanks for Landers Wells
Your pressure tank is critical for protecting your well pump and maintaining steady water pressure. In Landers, where wells produce 5-15 GPM from high desert alluvial and fractured granite, proper tank sizing and maintenance is essential.
How Pressure Tanks Work
A pressure tank stores pressurized water so your pump doesn't have to run every time you turn on a faucet. Key benefits:
- Reduces pump cycling (extends pump life)
- Maintains steady pressure throughout the house
- Provides small reserve for power outages
- Critical for Landers wells with yields of 5-15 GPM
Sizing Pressure Tanks for Landers Wells
Tank size depends on your well's flow rate and household demand:
- Small households (1-3 people): 20-30 gallon tank for Landers wells producing 5
- Medium households (4-5 people): 40-60 gallon tank
- Large households or farms: 80-120 gallon tank, especially if well yield is on lower end (5-15 GPM)
Pressure Tank Considerations for Landers
Landers wells in high desert alluvial and fractured granite typically produce 5-15 GPM. This affects tank sizing:
- Lower yields need larger tanks to reduce pump cycling
- Higher yields can use smaller tanks but still need adequate capacity
- Water quality (hard water (12-18 grains), high TDS, low yields in granite) affects tank lifespan
Signs Your Landers Pressure Tank is Failing
- Waterlogging: Pump cycles on/off rapidly (short cycling)
- Low pressure: Water pressure drops suddenly, especially upstairs or at far fixtures
- Tank leaking: Water pooling around base, rust spots
- No air cushion: Tank sounds "full" when tapped (should sound hollow at top)
- Pump running constantly: Tank can't hold pressure
Common Pressure Tank Problems in Landers
Based on local conditions and high desert alluvial and fractured granite:
- Hard water, high TDS, low yields in granite, very remote location (slow service response), aging wells, heat damage to equipment, storage tanks often needed
- Hard water (12-18 grains) causes sediment buildup inside tank
- Water quality issues (hard water (12-18 grains), high TDS, low yields in granite) can corrode bladder or tank interior
- Freeze damage in winter (elevation 3,100ft means cold temps)
Pressure Tank Maintenance
- Annual inspection: Check pre-charge pressure (should be 2 PSI below cut-in)
- Drain sediment: Especially important with Landers water (hard water (12-18 grains), high TDS, low yields in granite)
- Check bladder: Bladder tanks last 5-10 years depending on water quality
- Monitor pressure switch: Should cut in around 40 PSI, cut out around 60 PSI
Tank Replacement for Landers Wells
When it's time to replace your pressure tank, we:
- Size correctly: Based on your well's 5-15 GPM yield and household needs
- Choose quality: Bladder tanks from top manufacturers (Well-X-Trol, Amtrol)
- Professional install: Proper placement, piping, pressure settings
- Test thoroughly: Verify pressure, flow rate, pump cycling
Service area: Landers proper, Reche Road area, Sunburst, Goat Mountain, Integratron area, and throughout Landers.
Response time: 130 min from Ramona, 100 min from Anza.
Pressure tank service in Landers
Call (760) 440-8520 for tank sizing, replacement, or repair.