Booster Pumps for Perris Wells
Many Perris properties need booster pumps due to low well yields (10-25 GPM), uphill locations, or large properties. If your pressure is weak or inconsistent, a booster pump may be the solution.
When Perris Properties Need Booster Pumps
- Low-yield wells: If your well produces on the lower end of 10-25 GPM, a booster pump helps maintain pressure
- Uphill homes: Properties above the well location lose 0.43 PSI per foot of elevation gain
- Long pipe runs: Large properties in East Perris, West Perris, Lake Perris area with distant irrigation or outbuildings
- Multiple fixtures: When showers, washing machines, irrigation run simultaneously
- Second-story bathrooms: Common in newer Perris homes, need 50-60 PSI upstairs
Why Perris Wells Often Need Booster Pumps
Perris wells in Perris Valley alluvial deposits produce 10-25 GPM. Combined with local factors:
- Growing Riverside County city. Lake Perris recreation area. Hot summers. Fast-growing with many new developments. Good alluvial well yields from valley floor. Mix of residential and agricultural.
- Common problems: Hard water, nitrates from agriculture, declining water table from rapid growth, aging agricultural wells, TDS creeping up in some areas
- Elevation: 1,400ft affects pressure requirements
Neighborhoods Where We Install Booster Pumps
We frequently install booster pumps in these Perris areas:
- East Perris: 10-25 GPM yield wells, elevation 1,400ft, often need pressure boosting
- West Perris: 10-25 GPM yield wells, elevation 1,400ft, often need pressure boosting
- Lake Perris area: 10-25 GPM yield wells, elevation 1,400ft, often need pressure boosting
- May Farms: 10-25 GPM yield wells, elevation 1,400ft, often need pressure boosting
- Nuevo area: 10-25 GPM yield wells, elevation 1,400ft, often need pressure boosting
Types of Booster Pumps for Perris
Constant Pressure Systems
Best for most Perris homes. Benefits:
- Maintains steady 50-60 PSI regardless of demand
- Variable speed motor adjusts to usage
- Eliminates pressure fluctuations
- Energy efficient (pump only runs as needed)
Standard Booster Pumps
Good for specific applications:
- Irrigation systems on large Perris properties
- Livestock watering
- Fire suppression systems
- Lower cost than constant pressure
Booster Pump Sizing for Perris Wells
We size based on:
- Well yield: Can't boost more than well produces (10-25 GPM)
- Elevation gain: Calculate PSI needed for uphill properties
- Peak demand: How many fixtures run simultaneously
- Pipe diameter and length: Friction loss in long runs
Installation Process
- Assessment: Measure current pressure, flow rate, identify problem areas
- System design: Size pump based on well yield (10-25 GPM) and needs
- Installation: Mount pump, plumb intake/discharge, wire controls
- Pressure adjustment: Set optimal pressure for your property
- Testing: Run all fixtures, verify pressure throughout property
Booster Pump Maintenance
- Annual inspection: Check seals, bearings, motor condition
- Filter cleaning: Intake screen or filter (critical with Perris water quality: hard water (12-20 grains), nitrates, high TDS in some areas)
- Pressure verification: Ensure system maintains target PSI
- Control check: Test pressure switch or VFD operation
Service area: East Perris, West Perris, Lake Perris area, May Farms, Nuevo area, and throughout Perris.
Response time: 50 min from the Ramona shop, 35 min from Anza office.
Need better water pressure in Perris?
Call (760) 440-8520 for booster pump consultation and installation.