Common Pump Issues in Perris
Wells in Perris typically range from 200-400ft with geology consisting of Perris Valley alluvial deposits. This means pumps here face unique challenges:
- Pump depth settings: Most Perris wells require pump settings between 200 and 400ft, which means your pump is working hard to lift water from deep underground.
- Typical yields: Perris wells produce 10-25 GPM, which affects pump sizing and horsepower requirements.
- Local water quality: hard water (12-20 grains), nitrates, high TDS in some areas — these contaminants can cause premature pump wear and motor failure.
Specific Problems We See in East Perris, West Perris, Lake Perris area
Hard water, nitrates from agriculture, declining water table from rapid growth, aging agricultural wells, TDS creeping up in some areas. Our technicians know these issues intimately because we've been servicing Perris wells since 2020.
Response time to Perris: 50 min from our Ramona shop, 35 min from our Anza office.
Pump Types for Perris Geology
Because of the Perris Valley alluvial deposits in Perris, we typically install:
- Submersible pumps for depths over 250 feet (most common in Perris)
- Specific horsepower: Based on your well's yield (10-25 GPM) and total dynamic head
- Stainless steel construction to handle hard water (12-20 grains), nitrates, high TDS in some areas
Signs Your Perris Well Pump is Failing
- Pressure drops below 40 PSI
- Pump runs continuously or cycles frequently
- Rusty or sandy water (common with Perris Valley alluvial deposits)
- High electric bills (pump working too hard)
- No water at all (complete failure)
Why Choose SCWS for Perris Pump Repair?
- Local geology expertise: We understand Perris Valley alluvial deposits and how it affects pumps
- Fast response: 50 min from the Ramona shop
- Licensed & insured: CSLB #1086994
- 24/7 emergency service available
Need pump repair in Perris?
Call (760) 440-8520 or request service online.