How deep are wells in Boron, CA?

The average well depth in Boron, California is 389 feet, based on 20 wells on record. Well depths range from 190 to 815 feet depending on geology and location.

How much does it cost to drill a well in Boron, CA?

Well drilling costs in Boron typically range from $17,505-$29,175 based on the 389-foot average depth. Call Southern California Well Service at (760) 440-8520 for a free estimate.

Average Well Depth in Boron, CA

Well Statistics for Boron

389ft

Average Depth

Wells on Record

190-815ft

Depth Range

64.5

Avg Yield (GPM)

Need a Well Drilled in Boron?

Expert well drilling, pump installation, and repair service in San Bernardino County.

📞 (760) 440-8520 Get Free Estimate →

Well Depth Distribution in Boron

Based on 20 wells drilled in Boron, California, the average depth is 389 feet. The median depth is 340 feet, which represents the typical well depth in the area.

190ft
Shallowest 389ft
Average 815ft
Deepest

Shallowest well: 190 feet
Deepest well: 815 feet
Average depth: 389 feet
Median depth: 340 feet

Geology and Groundwater in Boron

Wells in Boron reach moderate depths, averaging 389 feet. The area features a mix of alluvial deposits and bedrock formations, with depth varying based on specific location and proximity to fracture zones. San Bernardino County geology in this region typically involves decomposed granite overlaying harder rock, with groundwater found in fractures and weathered zones.

The average static water level (depth to water when the pump is off) in Boron wells is approximately 210 feet below ground surface.

Drilling Trends & Well Use

Wells Drilled by Decade

1950s

1990s

2000s

2010s

2020s

Wells by Use Type

Domestic 9 (45%)

Monitoring 8 (40%)

Public 2 (10%)

Industrial 1 (5%)

Estimated Drilling Cost in Boron

Based on the average well depth of 389 feet, drilling a new well in Boron typically costs between $17,505 and $29,175. This includes drilling, casing, pump installation, and basic connections. Actual costs vary based on geology, access, and permit requirements.

🔍 Try our free Well Depth Lookup Tool to check well records near your specific address.

📍 Nearby Cities — Well Depth Data

📚 Related Resources

Get Expert Advice for Your Boron Property

Southern California Well Service has drilled hundreds of wells across San Bernardino County. We know the local geology and can give you an accurate depth and cost estimate.

Call (760) 440-8520

Licensed C-57 Contractor. CSLB License #1086994.| San Diego, Riverside & San Bernardino Counties

We service all major pump brands including Franklin Electric, Grundfos, Goulds (Xylem), and Sta-Rite (Pentair). Our trucks carry common parts and components for same-day repairs.

Frequently Asked Questions

How do I know if my well pump needs repair?

Common signs include: no water or low pressure, pump cycling on and off rapidly (short cycling), unusual noises, dirty or sandy water, and higher-than-normal electric bills. Any of these warrant a professional inspection.

How much does well pump repair cost?

Simple repairs like pressure switch replacement run

50-$300. Motor or pump replacement typically costs ,500-$4,500 depending on well depth and pump type. We diagnose the issue before recommending repairs.

Can I repair my well pump myself?

Surface-level issues like pressure switch adjustment or breaker resets are safe DIY tasks. However, anything involving pulling the pump from the well requires specialized equipment and should be handled by a licensed contractor to avoid damaging the well casing.

Continue learning about well maintenance and troubleshooting