How to Find Out How Deep Your Well Is
Need Help With Your Well?
Why Well Depth Matters
Knowing your well depth is essential for:
- Pump replacement — Correct pump sizing
- Water level monitoring — Track changes over time
- Property records — Accurate documentation
- Treatment planning — Water quality varies by depth
How to Find Your Well Depth
1. Check Your Well Records
When your well was drilled, a well completion report was filed with the county. This includes total depth, casing depth, and water-bearing zones. Contact your county environmental health department.
2. Check Property Records
The well report may have been provided when you purchased your home. Check your closing documents or home inspection report.
3. Measure It Yourself
If you can access your well (and the pump is out), use a weighted measuring tape (well sounder) to measure from ground level to bottom.
4. Estimate from Pump Depth
If you know when the pump was last pulled, the installer may have recorded the pump setting depth. The well is typically deeper than the pump setting.
5. Professional Measurement
We can measure your well depth during a service call or inspection. We use calibrated equipment for accurate results.
Typical Well Depths in Southern California
| Area | Typical Depth |
|---|---|
| Ramona/Julian | 200-600 ft |
| Valley Center/Escondido | 150-500 ft |
| Fallbrook/Bonsall | 200-500 ft |
| Temecula/Murrieta | 200-600 ft |
| Hemet/San Jacinto | 150-400 ft |
What About Water Level?
Total depth is not the same as water level. Your well may be 400 feet deep, but the water level (static water level) might be at 150 feet. The difference matters for pump sizing and well capacity.
Questions About Your Well?
We're here to help with expert advice and service.
License #1013597 | Serving San Diego, Riverside & San Bernardino Counties
We service all major pump brands including Franklin Electric, Grundfos, Goulds (Xylem), and Sta-Rite (Pentair). Our trucks carry common parts and components for same-day repairs.
Frequently Asked Questions
How do I know if my well pump needs repair?
Common signs include: no water or low pressure, pump cycling on and off rapidly (short cycling), unusual noises, dirty or sandy water, and higher-than-normal electric bills. Any of these warrant a professional inspection.
How much does well pump repair cost?
Simple repairs like pressure switch replacement run
Related Articles
50-$300. Motor or pump replacement typically costsRelated Articles
,500-$4,500 depending on well depth and pump type. We diagnose the issue before recommending repairs.Can I repair my well pump myself?
Surface-level issues like pressure switch adjustment or breaker resets are safe DIY tasks. However, anything involving pulling the pump from the well requires specialized equipment and should be handled by a licensed contractor to avoid damaging the well casing.
Related Articles
Continue learning about well maintenance and troubleshooting
