How deep are wells in Coronado, CA?

The average well depth in Coronado, California is 50 feet, based on 57 wells on record. Well depths range from 13 to 300 feet depending on geology and location.

How much does it cost to drill a well in Coronado, CA?

Well drilling costs in Coronado typically range from $2,250-$3,750 based on the 50-foot average depth. Call Southern California Well Service at (760) 440-8520 for a free estimate.

Average Well Depth in Coronado, CA

Well Statistics for Coronado

50ft

Average Depth

Wells on Record

13-300ft

Depth Range

280.0

Avg Yield (GPM)

Need a Well Drilled in Coronado?

Expert well drilling, pump installation, and repair service in San Diego County.

📞 (760) 440-8520 Get Free Estimate →

Well Depth Distribution in Coronado

Based on 57 wells drilled in Coronado, California, the average depth is 50 feet. The median depth is 28 feet, which represents the typical well depth in the area.

13ft
Shallowest 50ft
Average 300ft
Deepest

Shallowest well: 13 feet
Deepest well: 300 feet
Average depth: 50 feet
Median depth: 28 feet

Geology and Groundwater in Coronado

Coronado benefits from relatively shallow groundwater, with wells averaging just 50 feet deep. The area's alluvial deposits and sedimentary formations allow easier access to productive aquifers. Shallower wells in this region typically use rotary drilling methods and can often be completed more quickly and at lower cost than deeper bedrock wells.

The average static water level (depth to water when the pump is off) in Coronado wells is approximately 18 feet below ground surface.

Drilling Trends & Well Use

Wells Drilled by Decade

1990s

2000s

2010s

2020s

Wells by Use Type

Monitoring 50 (88%)

Cathodic Protection 4 (7%)

Irrigation - Agriculture 1 (2%)

Domestic 1 (2%)

Irrigation - Landscape 1 (2%)

Estimated Drilling Cost in Coronado

Based on the average well depth of 50 feet, drilling a new well in Coronado typically costs between $2,250 and $3,750. This includes drilling, casing, pump installation, and basic connections. Actual costs vary based on geology, access, and permit requirements.

🔍 Try our free Well Depth Lookup Tool to check well records near your specific address.

📍 Nearby Cities — Well Depth Data

📚 Related Resources

Get Expert Advice for Your Coronado Property

Southern California Well Service has drilled hundreds of wells across San Diego County. We know the local geology and can give you an accurate depth and cost estimate.

Call (760) 440-8520

Licensed C-57 Contractor. CSLB License #1086994.| San Diego, Riverside & San Bernardino Counties

We service all major pump brands including Franklin Electric, Grundfos, Goulds (Xylem), and Sta-Rite (Pentair). Our trucks carry common parts and components for same-day repairs.

Frequently Asked Questions

How do I know if my well pump needs repair?

Common signs include: no water or low pressure, pump cycling on and off rapidly (short cycling), unusual noises, dirty or sandy water, and higher-than-normal electric bills. Any of these warrant a professional inspection.

How much does well pump repair cost?

Simple repairs like pressure switch replacement run

50-$300. Motor or pump replacement typically costs ,500-$4,500 depending on well depth and pump type. We diagnose the issue before recommending repairs.

Can I repair my well pump myself?

Surface-level issues like pressure switch adjustment or breaker resets are safe DIY tasks. However, anything involving pulling the pump from the well requires specialized equipment and should be handled by a licensed contractor to avoid damaging the well casing.

Continue learning about well maintenance and troubleshooting