How deep are wells in Devore, CA?

The average well depth in Devore, California is 235 feet, based on 58 wells on record. Well depths range from 40 to 560 feet depending on geology and location.

How much does it cost to drill a well in Devore, CA?

Well drilling costs in Devore typically range from $10,575-$17,625 based on the 235-foot average depth. Call Southern California Well Service at (760) 440-8520 for a free estimate.

Average Well Depth in Devore, CA

Well Statistics for Devore

235ft

Average Depth

Wells on Record

40-560ft

Depth Range

130.0

Avg Yield (GPM)

Need a Well Drilled in Devore?

Expert well drilling, pump installation, and repair service in San Bernardino County.

📞 (760) 440-8520 Get Free Estimate →

Well Depth Distribution in Devore

Based on 58 wells drilled in Devore, California, the average depth is 235 feet. The median depth is 220 feet, which represents the typical well depth in the area.

40ft
Shallowest 235ft
Average 560ft
Deepest

Shallowest well: 40 feet
Deepest well: 560 feet
Average depth: 235 feet
Median depth: 220 feet

Geology and Groundwater in Devore

Wells in Devore reach moderate depths, averaging 235 feet. The area features a mix of alluvial deposits and bedrock formations, with depth varying based on specific location and proximity to fracture zones. San Bernardino County geology in this region typically involves decomposed granite overlaying harder rock, with groundwater found in fractures and weathered zones.

The average static water level (depth to water when the pump is off) in Devore wells is approximately 75 feet below ground surface.

Drilling Trends & Well Use

Wells Drilled by Decade

1940s

1950s

1970s

1980s

1990s

2000s

2010s

2020s

Wells by Use Type

Domestic 40 (69%)

Public 12 (21%)

Unknown 3 (5%)

Test Well 2 (3%)

Industrial 1 (2%)

Estimated Drilling Cost in Devore

Based on the average well depth of 235 feet, drilling a new well in Devore typically costs between $10,575 and $17,625. This includes drilling, casing, pump installation, and basic connections. Actual costs vary based on geology, access, and permit requirements.

🔍 Try our free Well Depth Lookup Tool to check well records near your specific address.

📍 Nearby Cities — Well Depth Data

📚 Related Resources

Get Expert Advice for Your Devore Property

Southern California Well Service has drilled hundreds of wells across San Bernardino County. We know the local geology and can give you an accurate depth and cost estimate.

Call (760) 440-8520

Licensed C-57 Contractor. CSLB License #1086994.| San Diego, Riverside & San Bernardino Counties

We service all major pump brands including Franklin Electric, Grundfos, Goulds (Xylem), and Sta-Rite (Pentair). Our trucks carry common parts and components for same-day repairs.

Frequently Asked Questions

How do I know if my well pump needs repair?

Common signs include: no water or low pressure, pump cycling on and off rapidly (short cycling), unusual noises, dirty or sandy water, and higher-than-normal electric bills. Any of these warrant a professional inspection.

How much does well pump repair cost?

Simple repairs like pressure switch replacement run

50-$300. Motor or pump replacement typically costs ,500-$4,500 depending on well depth and pump type. We diagnose the issue before recommending repairs.

Can I repair my well pump myself?

Surface-level issues like pressure switch adjustment or breaker resets are safe DIY tasks. However, anything involving pulling the pump from the well requires specialized equipment and should be handled by a licensed contractor to avoid damaging the well casing.

Continue learning about well maintenance and troubleshooting