How deep are wells in Arlington, CA?

The average well depth in Arlington, California is 114 feet, based on 53 wells on record. Well depths range from 23 to 421 feet depending on geology and location.

How much does it cost to drill a well in Arlington, CA?

Well drilling costs in Arlington typically range from $5,130-$8,550 based on the 114-foot average depth. Call Southern California Well Service at (760) 440-8520 for a free estimate.

Average Well Depth in Arlington, CA

Well Statistics for Arlington

114ft

Average Depth

Wells on Record

23-421ft

Depth Range

6.0

Avg Yield (GPM)

Need a Well Drilled in Arlington?

Expert well drilling, pump installation, and repair service in Riverside County.

📞 (760) 440-8520 Get Free Estimate →

Well Depth Distribution in Arlington

Based on 53 wells drilled in Arlington, California, the average depth is 114 feet. The median depth is 103 feet, which represents the typical well depth in the area.

23ft
Shallowest 114ft
Average 421ft
Deepest

Shallowest well: 23 feet
Deepest well: 421 feet
Average depth: 114 feet
Median depth: 103 feet

Geology and Groundwater in Arlington

Arlington benefits from relatively shallow groundwater, with wells averaging just 114 feet deep. The area's alluvial deposits and sedimentary formations allow easier access to productive aquifers. Shallower wells in this region typically use rotary drilling methods and can often be completed more quickly and at lower cost than deeper bedrock wells.

The average static water level (depth to water when the pump is off) in Arlington wells is approximately 27 feet below ground surface.

Drilling Trends & Well Use

Wells Drilled by Decade

1900s

1910s

1920s

1930s

1940s

1950s

1960s

Wells by Use Type

Unknown 27 (51%)

Domestic 15 (28%)

Irrigation - Agriculture 8 (15%)

Test Well 2 (4%)

Industrial 1 (2%)

Estimated Drilling Cost in Arlington

Based on the average well depth of 114 feet, drilling a new well in Arlington typically costs between $5,130 and $8,550. This includes drilling, casing, pump installation, and basic connections. Actual costs vary based on geology, access, and permit requirements.

🔍 Try our free Well Depth Lookup Tool to check well records near your specific address.

📍 Nearby Cities — Well Depth Data

📚 Related Resources

Get Expert Advice for Your Arlington Property

Southern California Well Service has drilled hundreds of wells across Riverside County. We know the local geology and can give you an accurate depth and cost estimate.

Call (760) 440-8520

Licensed C-57 Contractor. CSLB License #1086994.| San Diego, Riverside & San Bernardino Counties

We service all major pump brands including Franklin Electric, Grundfos, Goulds (Xylem), and Sta-Rite (Pentair). Our trucks carry common parts and components for same-day repairs.

Frequently Asked Questions

How do I know if my well pump needs repair?

Common signs include: no water or low pressure, pump cycling on and off rapidly (short cycling), unusual noises, dirty or sandy water, and higher-than-normal electric bills. Any of these warrant a professional inspection.

How much does well pump repair cost?

Simple repairs like pressure switch replacement run

50-$300. Motor or pump replacement typically costs ,500-$4,500 depending on well depth and pump type. We diagnose the issue before recommending repairs.

Can I repair my well pump myself?

Surface-level issues like pressure switch adjustment or breaker resets are safe DIY tasks. However, anything involving pulling the pump from the well requires specialized equipment and should be handled by a licensed contractor to avoid damaging the well casing.

Continue learning about well maintenance and troubleshooting