How deep are wells in Sun City, CA?

The average well depth in Sun City, California is 222 feet, based on 241 wells on record. Well depths range from 30 to 906 feet depending on geology and location.

How much does it cost to drill a well in Sun City, CA?

Well drilling costs in Sun City typically range from $9,990-$16,650 based on the 222-foot average depth. Call Southern California Well Service at (760) 440-8520 for a free estimate.

Average Well Depth in Sun City, CA

Well Statistics for Sun City

222ft

Average Depth

241

Wells on Record

30-906ft

Depth Range

50.5

Avg Yield (GPM)

Need a Well Drilled in Sun City?

Expert well drilling, pump installation, and repair service in Riverside County.

📞 (760) 440-8520 Get Free Estimate →

Well Depth Distribution in Sun City

Based on 241 wells drilled in Sun City, California, the average depth is 222 feet. The median depth is 200 feet, which represents the typical well depth in the area.

30ft
Shallowest 222ft
Average 906ft
Deepest

Shallowest well: 30 feet
Deepest well: 906 feet
Average depth: 222 feet
Median depth: 200 feet

Geology and Groundwater in Sun City

Wells in Sun City reach moderate depths, averaging 222 feet. The area features a mix of alluvial deposits and bedrock formations, with depth varying based on specific location and proximity to fracture zones. Riverside County geology in this region typically involves decomposed granite overlaying harder rock, with groundwater found in fractures and weathered zones.

The average static water level (depth to water when the pump is off) in Sun City wells is approximately 71 feet below ground surface.

Drilling Trends & Well Use

Wells Drilled by Decade

1970s

1980s

1990s

2000s

2010s

Wells by Use Type

Domestic 147 (61%)

Monitoring 63 (26%)

Irrigation - Agriculture 13 (5%)

Cathodic Protection 9 (4%)

Unknown 3 (1%)

Other 2 (1%)

Public 2 (1%)

Sparging 1 (0%)

Estimated Drilling Cost in Sun City

Based on the average well depth of 222 feet, drilling a new well in Sun City typically costs between $9,990 and $16,650. This includes drilling, casing, pump installation, and basic connections. Actual costs vary based on geology, access, and permit requirements.

🔍 Try our free Well Depth Lookup Tool to check well records near your specific address.

📍 Nearby Cities — Well Depth Data

📚 Related Resources

Get Expert Advice for Your Sun City Property

Southern California Well Service has drilled hundreds of wells across Riverside County. We know the local geology and can give you an accurate depth and cost estimate.

Call (760) 440-8520

Licensed C-57 Contractor. CSLB License #1086994.| San Diego, Riverside & San Bernardino Counties

We service all major pump brands including Franklin Electric, Grundfos, Goulds (Xylem), and Sta-Rite (Pentair). Our trucks carry common parts and components for same-day repairs.

Frequently Asked Questions

How do I know if my well pump needs repair?

Common signs include: no water or low pressure, pump cycling on and off rapidly (short cycling), unusual noises, dirty or sandy water, and higher-than-normal electric bills. Any of these warrant a professional inspection.

How much does well pump repair cost?

Simple repairs like pressure switch replacement run

50-$300. Motor or pump replacement typically costs ,500-$4,500 depending on well depth and pump type. We diagnose the issue before recommending repairs.

Can I repair my well pump myself?

Surface-level issues like pressure switch adjustment or breaker resets are safe DIY tasks. However, anything involving pulling the pump from the well requires specialized equipment and should be handled by a licensed contractor to avoid damaging the well casing.

Continue learning about well maintenance and troubleshooting